Z-Wave Plus Remotec Smart Thermostat ZTS-500

In stock
SKU
REM_ZTS-500
$158.24

Translates Z-Wave thermostat commands to Air-conditioning IR control codes.

  • 24VС single & two stage conventional heating systems (gas/oil/electric)
  • Heat pump systems with up to two stages of heating (electric/gas)
  • Zoned forced air and zoned hot water (2 or 3 wire)
  • Millivolt systems (12-24Vac or DC source)
  • One or two stage cooling systems
  • Hybrid systems
  • Available modes: Off, Heat, Cool, and Auto

Introduction

The ZTS-500 is a security Z-Wave enabled thermostat designed to control residential HVAC systems. A security enabled Z-Wave Plus Controller must be used in order to fully utilize the product. Users can use local or remote control and monitor the temperature via an App on smartphones or computers while at home or away through a Z-Wave gateway. It can maximize energy conservation and comfort while minimizing the effort required to maintaining a desired
temperature in your home.

HVAC Systems Compatible

  • 24Vac single & two stage conventional heating systems (gas/oil/electric)
  • Heat pump systems with up to two stages of heating (electric/gas)
  • Zoned forced air and zoned hot water (2 or 3 wire)
  • Millivolt systems (12-24Vac or DC source)
  • One or two stage cooling systems
  • Hybrid systems

HVAC Systems Not Compatible

  • Radiant floor and wall heating systems
  • Geothermal systems
  • Multi-zoned systems
  • 110V or higher line voltage systems (e.g. electric baseboard heaters)

Note: Thick black, red, or white wires connected with wire nuts running to existing thermostat typically mean high voltage system.

Features List

  • Support "Frequently Listening Routing Slaves" (FLiRS) mode and "Always Listening" mode
  • Support Network Wide Inclusion (NWI) and Explore Frames
  • Support Security and Non- Security command
  • Support battery low and level report
  • Support Association Groups
  • Advanced features through Z-Wave configuration parameters
  • Temperature sensor calibration
  • Filter replacement reminder
  • Z-Wave Plus compliant
  • OTA (over-the-air) firmware upgradeability
  • Energy saving mode
  • Short cycle start up protection
  • Support AA x 4 alkaline batteries (No C-wire required) or standard HVAC 24Vac input

Thermostat Alerts Messages

  • Battery Low Indication
  • Filter Replacement
  • Defrost Function
  • Out of Temperature Range Control Function
technical-specifications

Technical Specification

  • HARDWARE
    • Z-Wave Chip 500 series
  • COMMUNICATION PROTOCOLS
    • Z-Wave: Z-Wave Plus
  • Z-WAVE GROUPS
    • Two groups and 2 devices each (nodes)
  • LED and Button
    • Curved white LEDs display (Wide viewing angle and high contrast ratio with 3 levels brightness control)
    • Resolution: 18 x 6 dots
    • VA: 64mm x 28mm
    • Status icons: 7 "<", ">", "+" and "–" control buttons and LEDs
  • POWER SUPPLY
    • Input: AC 100-240VAC, 50-60Hz
    • Output: AC 24 VAC +/- 20% 50/60Hz
    • Battery: AA x 4pcs
  • RELAY CONTACT
    • Voltage: 24 VAC 50/60 Hz
    • Current: 1A Max. (inductive)
  • TEMPERATURE DATA
    • Temp Unit: °F or °C
    • Temp Display Resolution: 1°F / 0.5 °C
    • Temp Measurable Range: 32 – 99 °F / 0 – 37 °C
    • Temp Setting Range: 41 – 99 °F / 5 – 37 °C
    • Temp Swing and Differential: 1°F, 2°F, 3°F or 4°F / 0.5°C, 1.0°C, 1.5°C or 2°C
    • Temp Dead Band: 3°F, 4°F, 5°F or 6°F / 1.5°C, 2.0°C, 2.5°C or 3°C
  • DIMENSIONS
    • 160mm x 100mm x 28mm (HxWxD)
  • CERTIFICATIONS
    • FCC, CE, RoHS, Z-Wave Plus, ZigBee, Bluetooth, Wi-Fi
  • POWER CONSUMPTION
    • up to 8W
  • RADIO SIGNAL POWER
    • up to 0.8mW
  • RANGE
    •  up to 50m (outdoors) and 40m (indoors)
  • OPERATIONAL TEMPERATURE
    • 0-50°C
  • STORAGE TEMPERATURE:
    • -5-60°C
  • IP CODE
    • IP20

Package content

  • Main unit
  • Power supply

Z-Wave Specification

Z-Wave Association Capabilities


Group ID

Maximum Nodes

Description

1 1 AUTO repoet
2 3 Heater
3 3 Compressor

Z-Wave Configuration Capabilities


Parameter Number

Parameter Size

Parameter Name

Parameter Values

1 2 Scale of temperature 0 to 1
(Default)
10 2 Sensor Temperature Calibration 0 to 10
(Default)
11 2 LED Brightness Level 1 to 3
(Default)
12 2 Sleep Timer 3 to 60
(Default)
Seconds
13 2 Repeat Basic Set Counter 3 to 255 Minutes
14 2 Auto Report Room Temperature 1 to 8
(Default)
15 2 Set Time Interval 0 to 16
(Default)
Hours
2 2 Swing 1 to 4
(Default)
3 2 Differential 1 to 4
(Default)
4 2 Dead band 3 to 6
(Default)
5 2 Heat Set Point 41 to 99
(Default)
Fahrenheit unit
6 2 Cool Set Point 41 to 99
(Default)
Fahrenheit unit
8 2 Set Filter Counter 500 to 4000
(Default)
Hours
9 2 Report Filter Counter 0 to 9999
(Default)
Hours

Z-Wave Command Classes


Supported Command Classes
 
        Association Group Information V2
        Association V2
        Basic
        Battery
        Configuration
        Device Reset Local
        Firmware Update MD V3
        Manufacturer Specific V2
        Powerlevel
        Security
        Sensor Multilevel V5
        Thermostat Fan Mode V4
        Thermostat Fan State V2
        Thermostat Mode V3
        Thermostat Operating State V2
        Thermostat Setpoint V2
        Version V2
        Z-Wave Plus Info V2
 
 
Controlled Command Classes
 
        Basic

User manual

Guides

  • Guides
More Information
EAN N/A
Z-Wave Plus: N/A
Security S2 Classes N/A
Z-Wave Hardware Platform ZM5202
Z-Wave Library Type Routing slave
Z-Wave Device Type Thermostat - HVAC
Z-Wave Role Type Listening Sleeping Slave
Technology Z-Wave+
Frequency N/A
Type of thermostat N/A
Signal Inputs N/A
Signal Outputs N/A
Type of sensor multisensor
Association groups 3
Manufacturer Remotec
Switch/Control Type N/A
Maximu Load 1A
Power source Power supply DC, Battery
Battery Type AA
Внутренняя/наружная установка Indoor
Mounting type Wall
OTA Firmware Updating Yes
Usage Monitor Temperature Humidity Light
Write Your Own Review
You're reviewing:Z-Wave Plus Remotec Smart Thermostat ZTS-500
Your Rating
Copyright © 2016 Swinestudio. All rights reserved.